ClearPix CFB22DN-H2 Guía de instalación descargar pdf (Pagina 19)

Reset to Factory Default Settings

If the encoder no longer functions as expected, you can choose to

restore the encoder to its factory default settings.

Use the firmware revert button to reset the encoder.

Figure: Firmware revert microswitch location on the rear of the

encoder

1. Disconnect power from the encoder.

2. Using a straightened paperclip or similar tool, gently press

and hold the firmware revert microswitch.

3. While continuing to hold the microswitch, power the

device. Release the microswitch after three seconds.

Caution — Do not apply excessive force. Inserting the tool

too far will damage the device.

Firmware Revert

Button

1 2 ... 14 15 16 17 18 19 20 21 22 23

Sin comentarios

ClearPix CFB22DN-H2 Guía de instalación Pagina 19